How to tile a backsplash in the bathroom

how to tile a backsplash how to tile a backsplash

Installing a tile backsplash is a small D.I.Y job which can really improve the appearance of your bathroom. It is an easy way to update or fully change the appearance of your bathroom vanity area. You can complete a bathroom tile backsplash within a short time. This is possible even if you don`t have previous tiling experiences. The skills and knowledge required in laying backsplash tiles are very easy to master but it requires preparation, patience and time to complete it. Things you require include push pins, pencil, tiles, tiling trowel, level, tile adhesive, grout float, grout mix, clean rags, drop cloth, water and white vinegar.

how to tile a backsplashThe following are steps on how to tile a backsplash in your bathroom. They include;
1. Start Clean.
Ensure that you clean off the wall. This provides a good surface for the tile adhesive. In case there are no stains it is as simple as dusting off the wall. Otherwise, scrub it with a scrub brush and a bathroom cleanser. After that, wipe it dry with a clean rag.

2. Draw a Grid.
When drawing a tiling grid on your work area, use a pencil. You will also require a level and a tape measure to help you. Each row or column should be the width of the tile you have chosen plus one of the tiling spacers. You should decide where the spacer should be for each row and column when drawing the grid. For instance, it can always be on the left and bottom. Therefore, when you place the tile it should be flush with the right and top.

3. Map the Grid.
You have to push the thumb pins into each intersection on the grid. This is important after you apply the tile adhesive because it will help you keep the guidelines in mind.

4. Apply Adhesive.
When you are applying the tile adhesive, chose an area which is approximately two or three feet square. Then lay down a coating of tile adhesive using a tiling trowel. After that, remove and ensure that you replace the push pins as you move. When the tile adhesive is on the wall you draw the toothed edge of the tiling trowel. Draw it across the adhesive to cut the channels on the surface.

5. Lay the Tiles.
Push a tile into its place when laying a tile on the wall. Use the push pins to guide your placement.

6. Use the Spacers.
Ensure that you set spacers as necessary. This will assist you to align further the tiles. Once the next tile is in place, remove the spacers on the side of the tile. The spacer on the bottom and top should remain. It will stop the tiles from sliding down the adhesive.

how to tile a backsplash7. Keep going.
You have to repeat the above steps until all of the tiles in the bathroom backsplash have been laid.

8. Apply Grout.
Ensure that you remove all the spacers and push pins when the adhesive is dry. Then mix the grout according to manufacturer`s directions. Using grout float, apply the grout to the wall. This is done by pushing the grout into the spaces between the tiles.

9. Clean your tile.
After the grout is dry, lay out a drop cloth underneath your backsplash. Then you make a cleaning solution. The cleaning solution should be of one part vinegar and one part water. With the solution using a scrubber and a sponge, clean the grout residue off the tiles.

In general, the above are the steps on how to tile a backsplash in your bathroom.

Posted in: Bathroom Improvement